Description
Multipurpose hydro-alcoholic solution, suitable for food use and sanitization of single-use protective masks in case of health emergency by Coronavirus COVID-19. Contains alcohol 75% vol.

Mode of use
1. Make an accurate handwash with soap for at least 40 seconds.
2. Remove the mask worn on the face using the elastics and trying to avoid touching it in its inner part.
3. Wash your hands again following the directions of point 1, wear a new pair of disposable gloves or alternatively sanitize your hands with a hydro-alcoholic solution at 75%-85% or other suitable disinfectant.
4. Place the mask on a previously cleaned/sanitized surface with soap and soap or hydro-alcoholic solution >70% or other suitable disinfectant, with the outer part upwards.
5. Spray evenly the hydroalcoholic solution >70% on all surface including elastic but without exceeding in wetting; it is sufficient that a uniform layer is sprayed on the entire surface.
6. Turn the mask and repeat the operation.
7. Allow the solution to complete evaporation in a protected place (at least 30 minutes, the drying time may vary according to the environmental conditions).
8. After drying, after the above-mentioned time, the mask is healthy, therefore avoid contaminating it, especially in the inner part. In case of persistence of alcohol smell it is recommended to further dry on a clean and healthy surface, otherwise store the mask in a plastic envelope until new use.

Components
Neutral ethyl alcohol, demineralized water.

Warnings
Don't smoke. Easily flammable. Do not store healthy mask inside or above unhealthy surfaces without the protection of plastic envelope. Do not use the reconditioned mask in case of obvious alterations. The inside of the mask should not be touched for any reason because you could run the risk of contamination that would favor the contagion.

Conservation
Store the container well closed.
Keep away from flames and sparks.

Format
50 ml bottle.

Cod. 102/A